🕝 Hyundai Ioniq 6

[jeff]

I've added the full set of 192 HV battery cell parameters, which should allow you to pull the cell voltage map from your car now.

https://github.com/ElectricSidecar/Hyun ... ll/1/files

Please refresh your vehicle parameters and confirm you're on SHA: 640acdc, and then check your Battery > Modules parameters (you might need to scroll to the bottom) and you should see a cell voltage chart.

Guide on refreshing your vehicle parameters: https://sidecar.clutch.engineering/help ... parameters

[Shaskan]

Done ! New SHA OK

For tension error « not enough data in the response »

[jeff]

Do they all return errors like that?

[jeff]

Can you export your OBD scan logs and email them to support@clutch.engineering? Follow this guide: https://sidecar.clutch.engineering/help ... -scan-logs

I'll need to look at the actual data responses to see where the mismatch is occurring.

[Shaskan]

It seems yes not checked all 192 but every check was the same error

[Shaskan]

Mail sent with logs

[jeff]

Looks like I went a little crazy with the offsets. Fixed now in SHA: c446210.

[Shaskan]

All good now !

Is it risky to let the scanner plugged all the time when car is off ?

[jeff]

I personally do not do that for a few reasons:

• It can drain your car's 12V battery.
• It can create a potential security risk, because anyone can connect to your scanner and potentially get access to your vehicle.

[jeff]

Is the cell chart loading correctly at the bottom of the page?