🕦 2023 Hyundai Kona Electric Support

Post by **jeff** » Thu Oct 17, 2024 9:00 pm

Ok added a bunch more parameters in SHA: 1af468c, namely the HV cell pack parameters, state of health, and maybe watt-hours remaining in the pack.

Post by **UnnDunn** » Sun Oct 20, 2024 9:45 pm

Hi all. I’m trying to onboard my 2022 Hyundai Kona Electric and running into similar issues. Can I help with the troubleshooting?

Post by **jeff** » Mon Oct 28, 2024 4:47 am

@UnnDunn which parameters are you seeing populate when you try to connect?

Post by **jeff** » Mon Oct 28, 2024 4:48 am

@UnnDunn Oh I just noticed you haven't registered for the beta group yet; can you follow the steps in http://sidecar.clutch.engineering/beta/ so that I can make sure to track you appropriately as we onboard your car?

Post by **patmondal** » Tue Oct 29, 2024 1:56 pm

This is what i get in my 2019 Kona. Don’t have access to Terminal to enter the codes

Post by **UnnDunn** » Tue Oct 29, 2024 4:44 pm

jeff wrote: ↑Mon Oct 28, 2024 4:48 am
@UnnDunn Oh I just noticed you haven't registered for the beta group yet; can you follow the steps in http://sidecar.clutch.engineering/beta/ so that I can make sure to track you appropriately as we onboard your car?

Done.

Post by **jeff** » Fri Nov 01, 2024 5:49 am

@Kona electric owners: I'm currently waiting on OBD logs from anyone with a Kona Electric in order to start diagnosing why parameters might not be appearing. Please follow the instructions at https://sidecar.clutch.engineering/help ... -scan-logs after you've attempted a scan session with your car and then email the logs to support@clutch.engineering.

v1.20.1 was also just released today, so please make sure you're up-to-date in the App Store: https://apps.apple.com/us/app/electric- ... 1663683832

Post by **patmondal** » Sat Nov 02, 2024 1:32 pm

Sent email of logs

Post by **jeff** » Sat Nov 02, 2024 2:08 pm

@Kona electric owners Summarizing where we're at with onboarding so far.

VIN detection

The Kona EV does not seem to be willing to report its VIN using any of the standard mechanisms, which can cause the scanner not to end up using any of the parameters we've defined for the vehicle.

I've put together a walk-through video on how to configure Sidecar to use an override VIN in this case: https://www.threads.net/@featherless/post/DB3yS-KM7kn

Please confirm you've set up the override behavior and then try doing another scanning session. You should see the various parameters appear in the Parameters page for your vehicle. Scroll through each of those to get Sidecar to try to pull the values, and then send another OBD logs export please to support@clutch.engineering.

Seeing if we can get the VIN to respond

Please also run the following commands in a terminal before sending the OBD export:

Code: Select all

ATSH7E2
0902

Post by **UnnDunn** » Mon Nov 04, 2024 6:20 am

I sent an export of the logs after performing the VIN override, sending the terminal commands and browsing the Connectables. Hope it’s helpful.

Cars Forum